Xadow - Breakout


Perhaps you want to connect various modules to Xadow. For example, an IR sensor which can detect whether someone is near by. You can connect the sensor to this Breakout Module.


  • A adapter
  • Compatible with all Grove Module in hardware
  • Dimensions: 25.43mm x 20.35mm


Below is the Demo to control a buzzer. You need to connect Grove - Buzzer to Xadow Breakout with a Grove cable and connect Xadow Breakout to Xadow Main Board with a FFC cable.

Xadow breakout not only can control some modules which are IIC communication or Serial communication, but also can control other modules because the two Grove connectors can be used as Digital port or Analog port. In other words, it can control all Grove modules.

The demo code like this:

Void setup()
    DDRD |=0x04;
void loop()
    PORTD |=0x04;
    PORTD &=~(0x04);

Now you can hear the buzzer “Bi Bi Bi”. You can replace it with Grove - LED and see the LED on/off.


Help us make it better

Welcome to the new documentation system of Seeed Studio. We have made a lot of progress comparing to the old wiki system and will continue to improve it to make it more user friendly and helpful. The improvement can't be done without your kindly feedback. If you have any suggestions or findings, you are most welcome to submit the amended version as our contributor via Github or give us suggestions in the survey below, it would be more appreciated if you could leave your email so that we can reply to you. Happy Hacking!